Guitar Cabinets for Metal in Drop Tunings: 4x12, 2x12, Speakers and Impedance

Swap the amp and the sound changes. Swap the cabinet and it changes even more, which surprises a lot of people the first time they try it. The cabinet and its speakers are the last filter your tone goes through, and in low tunings they're what decides whether the low end is tight or just boomy.
4x12, 2x12 or 1x12
- 4x12. Four 12" speakers in a big closed box. The classic metal cabinet: tight, deep low end and a lot of air moving. Also heavy and loud, as anyone who's carried one up a flight of stairs will tell you.
- 2x12. Two speakers, much smaller and lighter. A good closed-back 2x12 can get close to a 4x12 on a recording and is far easier to move around. In the room, though, it pushes less low end.
- 1x12. Compact and fine for home or a small amp, but in Drop B and lower it struggles to give you the same weight once the volume goes up.
Closed back or open back
- Closed back: the box is sealed. The low end is tighter and more focused, which is what you want for metal and low tunings.
- Open back: the sound spills out around the room. It feels wider and more natural for clean and crunch tones, but looser in the lows.
For low-tuned metal, closed back is the usual choice, and for good reason.
Speakers
Different speaker models have very different voices. Some of the ones used most in metal have strong upper mids that cut through a band, others are darker and smoother, and plenty of players mix two types in the same cabinet. When you're choosing, listen for:
- how tight the low string stays on palm mutes;
- how harsh the upper mids get with a lot of gain;
- how the cabinet sits with a real drum kit, not just on its own in a quiet room.
Impedance: match it safely
This is the boring bit that saves you an expensive repair. A tube amp needs a cabinet of the right impedance, usually 4, 8 or 16 ohms.
- Match the amp's output to the cabinet. A 16-ohm cabinet goes into the amp's 16-ohm output.
- Two cabinets change the total impedance. Two 16-ohm cabinets in parallel make 8 ohms, so check the amp's manual for the right output.
- Never switch on a tube amp without a cabinet or a load box connected. It can damage the output transformer.
Solid-state amps and power amps for modelers have their own minimum impedance, so check the manual for those too.
The digital side
In a modeler or a plugin, the cabinet is an impulse response, and the same ideas apply: closed-back 4x12 IRs are the usual starting point for metal. There's a whole guide on impulse responses if you want to go deeper.
To compare cabinets or IRs, use something simple and rhythmic, like the power chord exercise in Drop B at 90 BPM, and listen to the low end on every single chord.