Impulse Responses (IRs) Explained: Why the Cabinet Is Half Your Tone

If your modeler or plugin sounds fizzy or thin, don't blame the amp just yet. More often than not, the culprit is the cabinet simulation. In most digital rigs the cabinet is an impulse response, or IR, and swapping it can change your tone more than swapping the amp ever will.
What an IR actually is
An impulse response is a short audio file that captures how a speaker cabinet, a microphone and a room change a sound. It's made by playing a test signal through a real cabinet and recording it with a microphone. An IR loader then applies that "fingerprint" to your amp signal, and suddenly your amp sounds like it's coming out of that cabinet.
The catch is that an IR captures one exact setup: one cabinet, one speaker, one microphone, in one position. Move the mic a few centimetres and you get a different IR. That's why IR packs often come with dozens of files that sound only slightly different.
What changes the sound
- The cabinet. A closed-back 4x12 gives you the tight, punchy low end metal is known for. Open-back cabinets sound wider but looser in the lows.
- The speaker. Different speaker models have very different mids and highs. A lot of classic metal tones come from a handful of well-known British and American speakers.
- The microphone. A dynamic mic close to the speaker is the classic metal choice: focused and aggressive. Ribbon mics are darker and smoother.
- The position. Aimed at the centre of the speaker, the sound is brighter. Towards the edge, it gets darker and rounder.
Picking an IR for low tunings
- Start with a closed-back 4x12 and a dynamic mic. It's the most common starting point for modern metal, and for good reason.
- Listen to the low string, not only to chords. A good IR keeps the low notes tight on palm mutes without booming.
- Keep an ear on 2–4 kHz. Too much there sounds harsh with a lot of gain. Too little and the guitar vanishes in a mix.
- Match the levels. IRs come at different volumes. Compare them at the same loudness, or you'll always end up picking the loudest one.
Blending two IRs
Lots of players blend two IRs, for example a bright close-mic IR with a darker one. Keep them in phase (most IR packs are already aligned) and start with one at full level and the other lower. If the low end gets thinner when you bring in the second IR, the two are out of phase.
Where to get IRs
Most modelers and plugins come with a set of IRs, and plenty of cabinet makers and IR companies give away free sample packs. Start with what came with your rig, then add a free pack or two. You don't need hundreds. You need a couple you really know.
Try each new IR on something simple and rhythmic, like the power chord exercise in Drop B at 90 BPM, and listen for a clear, even low end on every chord.